cancel
Showing results for 
Search instead for 
Did you mean: 
badams5
Surveyor

Copying Module Not Working

Jump to solution

Hello ,

Though the command to copy a module to another course has worked previously, it seems to have stopped. The command to copy is there, it says it is starting the copying, but the module never shows up in my other course.

Is this a more widespread problem than with just me?

Thanks.

0 Kudos
1 Solution

Accepted Solutions
James
Navigator

@badams5 

It's been six weeks since I had to copy any modules, but I'll relay some of my experiences from then in the hopes that it helps.

There have been a few times that I was sure that I copied a module but then it never showed up in the destination course.

What was happening was that I was starting to type in our SIS code for the course. It was unique and there is only one match for it, but I found out that if I don't select the name of the course from the autocomplete list, it doesn't work.

This will not work: 

James_0-1613879797503.png

This will work:

James_1-1613879822568.png

 

Another issue I think I've had is if I try to copy multiple times (this was with a module item rather than a whole module, but I wanted to copy the resource to multiple courses), I had trouble getting it to work if I didn't refresh the page between copy attempts. That might also apply to copying multiple modules on the same page, I'm not sure. At least it got to the point where I just automatically reload the page before I try a second copy.

Finally, the lesson in the Canvas Instructor Guide on copying a module says that you must have the ability to add course content to the destination course. That's probably not the problem, but I thought I'd mention it.

View solution in original post

1 Reply
James
Navigator

@badams5 

It's been six weeks since I had to copy any modules, but I'll relay some of my experiences from then in the hopes that it helps.

There have been a few times that I was sure that I copied a module but then it never showed up in the destination course.

What was happening was that I was starting to type in our SIS code for the course. It was unique and there is only one match for it, but I found out that if I don't select the name of the course from the autocomplete list, it doesn't work.

This will not work: 

James_0-1613879797503.png

This will work:

James_1-1613879822568.png

 

Another issue I think I've had is if I try to copy multiple times (this was with a module item rather than a whole module, but I wanted to copy the resource to multiple courses), I had trouble getting it to work if I didn't refresh the page between copy attempts. That might also apply to copying multiple modules on the same page, I'm not sure. At least it got to the point where I just automatically reload the page before I try a second copy.

Finally, the lesson in the Canvas Instructor Guide on copying a module says that you must have the ability to add course content to the destination course. That's probably not the problem, but I thought I'd mention it.

View solution in original post